Filter
Top Products
27
Consumer SupportTroubleshooting TipsOperating InstructionsSafety Instructions
ge.com
Replacing the light bulb.
Cooktop Light/Nite Light
Replace with a 130 volt, 35 watt (max.) halogen
bulb. Order WB36X10213 from your GE supplier.
To replace the cooktop light/nite light,
first disconnect the power at the main
fuse or circuit breaker panel, or pull
the plug.
Remove the screw from the side of the
light compartment cover and lower the
cover until it stops.
Be sure the bulb is cool before
removing. Break the adhesive seal
by gently unscrewing the bulb.
Screw in the new bulb, then raise the
light cover and replace the screw.
Connect electrical power to the oven.
4
3
2
1
Remove screw.
CleanSteel
Use a clean, soft, light and lightly dampened cloth, then dry thoroughly. Do not use
appliance wax, polish, bleach or products containing any chemical agent on the CleanSteel
surfaces.
Plastic Color Panels
Use a clean, soft, lightly dampened cloth, then dry thoroughly.
Door Seal
It’s important to keep the area clean where the door seals against the microwave. Use only
mild, non-abrasive detergents applied with a clean sponge or soft cloth. Rinse well.
Bottom
Clean off the grease and dust on the bottom often. Use a solution of warm water and
detergent.