Filter
Top Products
T~
EX~UST
FEATURE
The exhaust hood
feature on your microwave oven is equipped with two
metal
filters which collect grease. When the fan is operated, air is drawn
up through the filters and is then discharged through the provided venting
to the outside.
METAL
I
METAL
FILTER
COOKTOp
FILTER
LIGHT
Reusable Grease Filters
The
gme
filters should be cleaned at least once a month. Never operate the microwave without the filters in
place.
In situations where flaming might occur on surfaces below hood, filters will stop the entry of flames into the
unit.
To Remove Grease Filter
To Clean and Replace Grease Filter
To remove grease filter,
To
clean grease filter, soak it
and then agitate filter
grasp the “finger hold”
in solution of hot water and detergent. Don’t use
on the filter and slide to
ammonia or ammonia products because they will
the rear. Then pull filter
darken the metal. Light brushing can be used to
downward and to the
remove embedded dirt.
front. The
filter
will
drop out.
Rinse, shake and remove moisture before replacing.
To
replace grease filter,
slide the filter in the frame
slot on the back of the opening.
Pull
filter upward and to the front to lock into place.
Charcoal Filter
Et
(for some mtie]s)
There is a Recirculating Charcoal Filter Kit available
Filter
Kit model
JX81
can be ordered from your GE
for models that are not vented to the outside.
supplier. Ask for part
WB02X4267.
GRO~~G
~STRUCTIONS
This appliance must be grounded.
In the event of an electrical short
circuit, grounding reduces the risk
of electric shock by providing an
escape wire for the electric current.
This appliance is equipped with a
power cord having a grounding
wire with a grounding plug. The
plug must be plugged into an outlet
that is properly installed and
grounded. (Fig. 1)
WARNING–Improper
use
of the grounding plug can
result in a risk of electric shock.
PREFERRED
METHOD
Where a standard two-prong
wall receptacle is encountered, it
is your personal responsibility and
obligation to have it replaced with
a properly grounded three-prong
wall receptacle.
Do not under
anv
circumstance
Ensure proper ground
cut or remove
th~
third (ground)
Fig. 1
exists before use
prong from the power cord.
Consult a qualified electrician or
Do not use an adapter plug with
this appliance.
service technician if the grounding
instructions are not completely
Do not use an extension cord
understood. or if doubt exists as to
with this appliance.
whether the appliance is properly
grounded.
42