Filter
Top Products
—
—
To replace hood lamp, first disconnect power at
n’mhl fuse or ch’clm !’mWker panel or pull plug.
Remove 2 screws from each side of lower panel,
steadythe smoke and spatter shield with cmi hand
while removing and replacing the 2 screws on each
side. Then remove the 3 screws from front edge.
Lower the panel until it rests on range below. Place
L7’-A :- ‘“.:
o
—=====—_—
To replaee your oven lamp,first disconnect power at
main fuse or circuit Im3akeror pull phqg.i?emov~the
top grill by taking off 2 screws which hold it in place,
Next, remove the single screw cm top left that
secures lamp housing, (On models so equipped,)
Open oven door for easier removalof the lamp hous-
ing assembly,Then grasp tab and pull out and up to
clear door hinge and front lip of oven, To remove
bulb, push it inward gently and t~rri to left, then pull
outward from socket, Replace with GE Lamp
x 25T8DC,
00 not attempt to operate the oven unless the grill is
in pkim.
..—...
fingers on tap near each end of lamp. Press down
and roll top of lampgently toward front until it stops.
Remove.Replacewith same type and wattage lamp.
Hold lamp near each end and insert prongs in
sockets.Gently roll top of lamp toward rear of range
until it stops, Raiselower panel and replace screws.
Clean off the grease and dust cm hood surfaces
often, Usea warm detergent solution. About 1table-
spoon of ammonia may be added to the water, Take
care not to touch the fiiters and enameled surfaces
with this. Ammonia will tend to darken metal, Wash
the smoke and spatter shield with a warm detergent
solution,
29
—