Filter
Top Products
Installation Instructions
6
STEP 6 INSTALL POWER CORD
Skip this step if dishwasher will be direct wired or has a
factory installed power cord.
Use Power Cord Kit WX09X70910, available for purchase
from an authorized GE Appliance Dealer. The power cord and
connections must comply with the National Electrical Code,
Section 422 and/or local codes and ordinances.
• Maximum power cord length is 6’.
• Connect incoming power cord white (or ribbed) to dishwasher
white, black (or smooth) to black and ground to dishwasher
green wire. Use UL listed wire nuts of appropriate size.
• Install junction box cover. Be sure wires are not pinched under
the cover.
Figure M
Figure L
STEP 5 REMOVE TOEKICK BRACE
Only for PDW9700 series and PDW9900 series, otherwise
proceed to Step 6.
• Remove the 2 toekick brace
screws (from the upper set of
mounting
holes) and
toekick brace.
Set aside
for use in
Step 19.
Figure J
STEP 3 REMOVE WOOD BASE,
INSTALL LEVELING LEGS
IMPORTANT – Do not kick off wood base! Damage
will occur.
• Move the dishwasher close to the installation location and lay
it on its back.
• Remove the four leveling legs on the underside of the wood
base with an adjustable wrench or 15/16" socket.
• Discard base.
• Screw leveling legs back into the dishwasher frame,
approximately 1/8" from frame as shown.
Approx.
1/8"
05A-1183Q
Figure K
STEP 4 REMOVE TOEKICK
• Remove the 2 toekick screws
and toekick.
Set aside
for use in
Step 19.
PDW9200-PDW9900, CDW9000 Series
Figure I
Tip: If door does not open easily or falls too quickly, check the
spring cable routing. Check that the cable is properly aligned
on the pulley. See Figure I .