Filter
Top Products
7
Consumer SupportTroubleshooting TipsOperating InstructionsSafety Instructions
Flashing display lights.
Status Indicator Lights What It Means
START/RESET Cycle has been interrupted by pressing the START/RESET pad. Light will
quit flashing after the dishwasher automatically drains out the water.
Recommended dishwasher products.
GE recommends the following products for use in
its dishwashers:
■ Electrasol,
®
Cascade
®
and Cascade Complete
™
Dishwasher Detergents.
■ Jet Dry
®
and Cascade Rinse Aid
®
to remove spots
and prevent new film buildup on your dishes,
glasses, flatware, cookware and plastic.
■ Cascade
®
Plastic Booster
™
to remove red staining
inside your dishwasher that can come from some
tomato-based stains.
■ Cerama Bryte
®
Stainless Steel Appliance Cleaner
to clean the stainless steel panel of GE and
Profile
™
stainless exterior dishwashers.
■ Jet Dry
®
Dishwasher Cleaner to help remove
some hard water mineral stains that can occur
in hard water conditions.
Clean
PDW8100–PDW8800 Series
The CLEAN light is illuminated when the selected cycle and enhancements are complete. The light will stay ON until
the door is opened.
PDW9200–PDW9800 Series
The CLEAN light is illuminated and a double beep will sound when the selected cycle and enhancements are complete.
You may remove the dishes at any time. Note the high-efficiency fan will run quietly for 30 minutes to 4 hours (depending
on selected cycle) after the CLEAN light is illuminated to continue drying the dishes. This can be interrupted by opening
the door and pressing any keypad.
NOTE: To turn off the double beep indicator (or re-activate it if it was previously disengaged), press the HEATED DRY
pad 5 times within 3 seconds. A triple beep will sound to indicate the end-of-cycle beep option has been toggled.
6
www.GEAppliances.com