Filter
Top Products
4
Operating Instructions Safety InstructionsConsumer Support Troubleshooting Tips
About the dishwasher control panel.
You can locate your model number on the tub wall just inside the door. Throughout this manual, features and appearance may vary from your model.
Control Settings
Status Indicator Lights (Indicators vary by models)
The Status display tells you what is happening while the dishwasher is in operation and may flash,
indicating a malfunction. The lights will come ON indicating the sequence of the dishwasher operation.
LOW DETERGENT Displayed when the SmartDispense needs to be refilled with liquid or gel automatic
dishwasher detergent.
SENSING Displayed while the Clean Sensor
™
is measuring the amount of soil and temperature
of water. The dishwasher will adjust the selected cycle to achieve optimal performance.
WASHING Displayed during prewash, main wash and rinse periods.
DRYING Displayed during HEATED DRY.
SANITIZED Displayed when cycle has met sanitization conditions.
CLEAN Displayed when a wash cycle is complete.
Time Remaining Display (on some models)
During operation, the display shows the minutes remaining until the cycle is complete. The display may
adjust the remaining time while the Sensing light is on. The time displayed at the start of each cycle may
change from the factory setting as the unit customizes itself to home use. During a delay start, the display
will show hours of time remaining until the cycle starts.
Selections
PDW8900 Series: Press the pad for the desired wash cycle.
PDW9700 and PDW9900 Series: Use the Arrow Pads to scroll through the wash cycles.
NOTE: All cycle times and water usage information contained in the following section are approximate
values only. Actual results will depend on several factors, including but not limited to, inlet temperature,
household water pressure and turbidity of the wash water.
The light above or next to the selected pad will be ON to indicate which WASH CYCLE has been selected.
ANTI-BACTERIA Heavy 7.8 gal., 105 min.
Medium 6.7 gal., 95 min.
Light 5.6 gal., 85 min.
This cycle raises the water temperature in the final rinse to sanitize your dishware. The
cycle length will vary depending on the temperature of your inlet water.
NOTE: The Anti-Bacteria cycle is monitored for sanitization requirements. If the cycle is
interrupted during or after the main wash portion or if the incoming water temperature is
so low that adequate water heating cannot be achieved, the sanitizing conditions may
not be met. In these cases, the sanitized light will not illuminate at the end of the cycle.
NOTE: NSF-certified residential dishwashers are not intended for licensed food
establishments
.
3
2
1
1
2
3 45
6
PDW8900 Series
LOW DETERGENT
Smart Dispense
S
ENSING
W
ASHING
D
RYING
S
ANITIZED
C
LEAN
R
INSE
O
NLY
S
INGLE
R
ACK
W
ASH
P
LASTIC
C
YCLE
C
HINA
C
YCLE
S
PEED
C
YCLE
N
ORMAL
COOKWARE
ANTI-BACTERIAL
5
62 43
1
PDW9700 Series and PDW9900 Series