Filter
Top Products
7
Consumer Support
Troubleshooting TipsOperating InstructionsSafety Instructions
Flashing display lights.
Status Indicator Lights What It Means
START/RESET Cycle has been interrupted by pressing the START/RESET pad. Light will quit
flashing after the dishwasher automatically drains out the water.
Recommended dishwasher products.
GE recommends the following products for use in
its dishwashers:
■ Cascade
®
and Electrasol
®
powder, liquid or gel
automatic dishwasher detergents.
■ Jet Dry
®
and Cascade Crystal Clear
®
to remove
spots and prevent new film buildup on your dishes,
glasses, flatware, cookware and plastic.
■ Cascade
®
Plastic Booster
™
to remove red staining
inside your dishwasher that can come from some
tomato-based stains.
■ Cerama Bryte
®
Stainless Steel Appliance Cleaner
to clean the stainless steel panel of GE and Profile
™
stainless exterior dishwashers.
■ Jet Dry
®
Dishwasher Cleaner to help remove some
hard water mineral stains that can occur in hard
water conditions.
Clean
PDW8700 Series and PDW8800 Series
The CLEAN light is illuminated when the selected cycle and enhancements are complete. The light will
stay ON until a pad is pressed or the door is opened and then closed.
PDW9200 Series and PDW9800 Series
The CLEAN light is illuminated and a double beep will sound when the selected cycle and enhancements
are complete. You may remove the dishes at any time. Note the high-efficiency fan will run quietly for 30
minutes to 4 hours (depending on selected cycle) after the CLEAN light is illuminated to continue drying
the dishes. The fan can be turned off by opening the door and pressing any keypad.
NOTE: To turn off the audible end-of-cycle signal (or re-activate it if it was previously disengaged), press
the HEATED DRY pad 5 times within 3 seconds. A triple beep will sound to indicate the end-of-cycle beep
option has been toggled.
6
ge.com