GE PSB1201SS Oven User Manual


 
15
Installation Instructions
INSTALL MOUNTING SCREWS
Slide the oven the remaining way into the opening
so that the side flanges and control panel are
against the cabinet frame. Make sure that the oven
is centered in the opening.
Open the door, place a turntable tray in the oven
and make sure that the tray in the unit is level.
Drill pilot holes through the side flanges.
Drive the color-matched screws into the side
flanges. It is recommended that the screws
be hand tightened.
If installing oven with an accessory storage
drawer:
Open the drawer.
Drill pilot holes through the side flanges.
Drive color-matched screws into the side flanges.
It is recommended that the screws be hand
tightened.
NOTE: If installing the Profile Advantium 120V Oven
with an accessory storage drawer, you must use
the Under-the-Counter (UTC) mounting bracket for
the drawer.
If installing the Monogram Advantium integrated
model ZSC1201 above 36, the UTC mounting bracket
for the accessory storage drawer must be used.
6
FINALIZE INSTALLATION
Turn power on at the source. The interior light
should come on when the door is opened.
Refer to Owner’s Manual for operating instructions.
7
INSTALL BOTTOM TRIM
CAUTION: If installing the Advantium
120V Oven below 36, you must use the plastic
bottom trim due to burn risk to children. The plastic
trim acts as insulation and will help prevent burns
to children from hot surfaces.
NOTE: If installing the Advantium 120V Oven
with an accessory storage drawer, the bottom trim
is not required. Proceed to Step 5.
• Installation Below 36, align trim tabs on the plastic
trim to slots in the bottom of the oven.
• Installation Above 36, align trim tabs on the plastic
or metal trim to slots in the bottom of the oven.
Secure the bottom trim to the bottom of the oven
using 3 screws provided.
4
INSTALL BOTTOM TRIM WITH
ACCESSORY DRAWER
If installing with an accessory drawer, see
installation instructions on page 17 or instructions
that come with the accessory drawer.
5
Metal Trim
Plastic Trim
OR
Plastic Trim