GE PSW23PSR Refrigerator User Manual


 
PSW23PSR – GE Profile Arctica CustomStyle
ENERGY STAR
®
22.6 Cu. Ft. Stainless-Wrapped
Side-By-Side Refrigerator with Dispenser
TM
Specification Revised 7/04
210265
Water Line Coupler
1.
366-15A
Hinge Screws
Wire Harness
Toekick Screw
4.
3.
2.
To Remove Top Cap and Doors on PSW23PSR
Step 1: Locate and remove two Phillips head screws on the top of
the refrigerator. Remove two screws, one on each side at the
rear of the top cap. Lift off and remove top cap.
Step 2: Open both doors. Remove one screw on each side of the
toekick. Pull forward to remove toekick.
Step 3: On the freezer door, disconnect water line coupler by
pushing
against the collar on the left side. Disconnect
wire harness.
Step 4: Use a Torx T-20 screwdriver to remove 2 screws holding the
top hinge. Carefully remove hinge while supporting door.
Lift door up and off bottom hinge. Remove fresh food door in
the same manner. Note: Do not remove bottom hinges! Door
alignment will be difficult if bottom hinges
are removed.
Step 5: Place refrigerator onto a hand truck, upright and against one
side. Move refrigerator to the installation location.
Reinstall Doors, Top Cap
Step 6: Carefully lower doors onto bottom hinges. Be sure to route
the tubing and electrical connector through the bottom
hinge. Reinstall top hinges.
Step 7: Place cap over the top of the refrigerator. Reinstall the
original screws in the top and back of the cap.
Step 8: Reconnect the wiring harness and waterline.
R
Listed by
Underwriters
Laboratories
For answers to your Monogram,
®
GE Profile
or
GE
®
appliance questions, visit our website at
GEAppliances.com or call
GE Answer Center
®
service, 800.626.2000.
R
Total volume and shelf
area are calculated by
the Association of Home
Appliance Manufacturers’
standards.
As an ENERGY STAR
®
partner, GE has determined
that this product meets the
ENERGY STAR
guidelines
for energy efficiency.