Filter
Top Products
7
ZTBSS1 Monogram Tubular Handle Kit
BEFORE YOU BEGIN:
Read these instructions completely and carefully.
IMPORTANT – Save these instructions
for local inspector’s use.
IMPORTANT – Observe all governing codes
and ordinances.
Note to Installer – Be sure to leave these
instructions with the Consumer.
Note to Consumer – Keep these instructions
with your Owner’s Manual for future reference. This kit
provides a stainless steel tubular handle to coordinate
with other Monogram appliances.
• The tubular handle must be installed onto the 3/4″ thick
portion of the custom wood panel before the panel is
secured to the door.
TOOLS AND MATERIALS REQUIRED
• Gloves to protect against sharp edges
• #2 Phillips screwdriver
• Drill and 1/4″ bit and 1/2″ spade bit
• Safety glasses
• Center punch
• Pencil
THIS KIT INCLUDES
• Tubular handle
• 2 Mounting screws
• 2 Handle standoffs
• 2 Set screws for standoffs
• 2 Nuts
• 2 Washers
• Allen Wrench
INSTALL THE TUBULAR HANDLE
• Use the handle as a template to locate and mark the
exact position of the screw holes. Be careful to avoid
interference with custom panel mounting screws.
• Draw a pencil line, top to bottom and 7/8″ from the
outside edge.
• Hold the tubular handle against the appearance side,
centered on the marked line.
• Mark the screw hole locations at the center of the
handle attachment posts.
• Center punch the marked hole locations. Drill 1/4″
pilot holes from the appearance side through the
entire panel thickness.
• Use a 1/2″ spade bit to drill 1/4″ to 5/16″ deep into
the back side of the panel. Insert washer (spacer) into
the hole.
• Install screw through the handle standoff and into the
pilot hole.
• Fasten nut onto the screw until the standoff is tight
against the panel. The screw hole on the standoff
should be pointing down toward the floor.
• Place handle attachment posts inside the standoffs.
• Use the Allen wrench to install the set screws. Tighten
handle to standoffs.
Handle
Standoff
Handle
Attachment
Post
Tubular
Handle
Screw
Set
Screw
Washer
Nut
Custom
Framed
Panel
30”
24-7/32”
7/8”