GE WB48X10057 Cookware User Manual


 
Consumer Support Troubleshooting Tips Care and Cleaning Operating Instructions Safety Instructions
24
Troubleshooting Tips
Before you call for service…
Problem Possible Causes What To Do
“F – and a number You have a function Disconnect all power to the range for at least 30
or letter” flash error code. seconds and then reconnect power. If the function
in the display error code repeats, call for service.
On self-cleaning models, if a function error code
appears during the self-cleaning cycle, check the oven
door latch. The latch may have been moved, if only
slightly, from the locked position. Make sure the latch
is moved to the right as far as it will go. Touch the
CLEAR/OFF pad. Allow the oven to cool for one hour.
Put the oven back into operation.
Display flashes “bAd” The installed connection Contact installer or electrician to correct miswire.
then “linE” with a from the house to the unit
loud tone is miswired.
Display goes blank A fuse in your home may be Replace the fuse or reset the circuit breaker.
blown or the circuit
breaker tripped.
The clock is turned off from See the Using the clock and timer section.
showing in the display.
Display flashes Power failure. Reset the clock.
Unable to get the Oven control pads were The BAKE and BROIL HI/LO pads must be touched
display to show “SF” not pressed properly. at the same time and held for 3 seconds.
Power outage, Power outage or surge. Reset the clock. If the oven was in use, you must reset
clock flashes it by touching the CLEAR/OFF pad, setting the clock
and resetting any cooking function.
“Burning” or “oily” This is normal in a new To speed the process, set a self-cleaning cycle
odor emitting from oven and will disappear for a minimum of 3 hours. See the Using the
the vent in time. self-cleaning oven section.
Strong odor An odor from the insulation This is temporary.
around the inside of the
oven is normal for the first
few times the oven is used.