Filter
Top Products
Questions ?
Use this
problem
so[_er
PROBLEM POSSIBLE CAUSE WHAT TO DO
Stained tub interior
Detergent with
colorant was used
Dishes and flatware
not clean
Spots and filming on
glasses and flatware
Some tomato-based
foods can stain
Inlet water temperature
is below 120°F.
.Some detergents contain colorant
(pigment or dyes) that will discolor tile
mb interior with extended use. Check tile
detergent cup fbr signs of any
discoloration. If cup is discolored,
change to detergent widlout aW colorant.
"Use of the RINSE & HOLD wcle (on
some models) after adding tile dish to tile
load can decrease tile level of staining.
.Raise tile water heater temperature to
120°F.
.Use HI TEMP WASH.
Water pressure is .Turn on a fm._cet. Is water coming out
temporarily low more slowly than usual? If so, wait until
pressure is normal be%re using your
dishwasher.
Air gap is clogged .Clean tile air gap.
Improper rack loading .Make sure large dishware does not
block tile detergent dispenser or tile
wash arm.
Extremely hard
water
Low inlet water
temperature
Overloading tlle dishwasher
Improper loading
Old or damp powder
detergent
Rinse agent dispenser
empty
Too little detergent
•Use JET-DRY _ rinse agent to remove spots
and prevent new film build-up.
•To remove stubborn spots fl'om glassware:
f Remove all metal utensils fi'om tile
dishwasher.
2 Do not add detergent.
3 Select tile POT PANS cycle and
HEATED DRY opuon.
4 Start tile dishwasher and allow to run
fur 26 minutes. Dishwasher will
now be in tile main wash.
Open tile door and pour 2 cups
(500 ml)of white vinegar into tile
bottom of tile dishwasher.
Close tile door and allow to complete
tile cycle. If vinegar rinse doesn't
work: Repeat as above, except use
1/4 cup (60 ml) of citric acid custals
instead of vinegar.
17