GE ZBD6700 Dishwasher User Manual


 
25
Questions?
Use this
problem
solver
PROBLEM POSSIBLE CAUSE WHAT TO DO
Suds in the tub Correct detergent
Use only automatic dishwasher detergents
was not used to avoid sudsing.
To remove suds from the tub, open the
dishwasher and let suds evaporate. Add
1 gallon of cold water to the tub.
For 7000 series models:
Pump out water by pressing the
NORMAL WASH button; then press the
START/CANCEL button.
Close the door until it locks into place.
Wait for one minute; then carefully
open the door and hold down the
START/CANCEL button for three seconds.
For all other models:
Pump out water by closing the door until it
locks into place.
Press the NORMAL WASH button; then
press the START/CANCEL button.
Wait for one minute; then press and hold
down the START/CANCEL button for
three seconds. Repeat if necessary.
Too much rinse agent used
Remove any spilled rinse aid.
Reduce rinse aid setting.
For soft water, rinse aid may be unnecessary.
Dishes and flatware Improper rack loading Make sure large dishware does not block
not clean the detergent dispenser or the wash arm.
Assure silverware is not blocking spray
arm.
Filter or spray arms dirty Clean filters and spray arms according to
instructions on page 22.
Inlet water temperature is Run tap until water is hot, prior to starting
below 120°F dishwasher cycle.
Raise the water heater temperature to
120°F.
Depending on model, use WATER TEMP
HIGH or WATER TEMP SANI option if
suitable for dish load.
Air gap is clogged Clean the air gap.
Water pressure is Turn on a faucet. Is water coming out
temporarily low more slowly than usual? If so, wait until
pressure is normal before using your
dishwasher.