Filter
Top Products
Cutlery Tray
The cutlery tray holds up to 4 large knifes such
as a carver, chef’s knives, bread knife, etc., that
are too tall to fit in the silverware basket.
Hook the tray onto the rear of the upper rack.
Lay the knives between the guides (as shown).
Bowl Tines
The special large-bowl tines in the lower rack
add flexibility to your loading pattern. They
are useful for serving bowls or other large
bowls.
To use the bowl tines, fold down the 2 rows of
flex tines in front of the bowl tines and load
bowls just as you would in the upper rack.
You can remove the upper rack to allow space
for large items in the lower rack.
To remove the upper rack, unsnap and remove
the end caps on each side of the rails.
Pull the rack straight out and off the rails.
Replace the end caps, then push the rails all
the way back into the dishwasher. Slide the
shower nozzle attachment over the spout.
Then fill the lower rack and begin your cycle.
NOTE: Nozzle must be in place with upper
rack removed. If not installed properly, poor
wash performance and noise will result.
NOTE: Don’t forget to remove the shower
nozzle attachment before you replace the
upper rack.
15
Lower Rack
The lower rack is best used for plates, saucers
and cookware. Large items such as broiler pans
and baking racks should go along the left-hand
side. Load platters, pots and bowls along the
sides, in corners or in the back. The soiled side
of items should face the center of the rack. If
necessary, oversized glasses and mugs can be
placed in the lower rack to maximize loading
flexibility.
Also, be careful not to let a portion of an item
such as a pot or dish handle extend through
the bottom rack. This could block the wash
arm and cause poor washing results.
Fold-down tines (on some models) provide
flexibility for extra-large and hard-to-fit items.
The tines may be left in the up position or
folded down to customize the lower rack.
Shower nozzle
attachment
These tines fold down
Large-bowl tines
Remove the
Upper Rack
Extra Rack
Features
(on some
models)
Remove end cap
Unsnap