Filter
Top Products
Care and Cleaning
Ice maker
Vacation
and moving
To shut down the ice maker:
1. Unplug the ice maker or disconnect power.
2. Remove all ice from the storage bin.
3. Shut off the water supply. If the ambient
temperature of the room will drop below 32°F
(0°C), water must be removed from the drain
line.
For ice makers with a drain pump installed:
1. Plug in ice maker or reconnect power.
2. Turn ice production off and remove all
remaining ice from ice bin.
3. Pour 1 gallon. (3.78541 L) of water into the ice
bin near the drain and let the ice maker stand
for approximately 5 minutes. This will allow
the water in the bin to drain into the drain
pump so the pump will remove the remaining
water from the ice bin and drain the pump.
4. Unplug ice maker or disconnect power.
Before using again, clean the ice maker and
storage bin. Plug in the ice maker or reconnect
power and turn on the water supply tor resume
ice making operation.
Filter
replacement
Product designed and tested for use with
genuine GE water filters. Non-GE filters are not
covered under product warranty. Order part
number IMWF. In the U.S.A. call 1.800.626.2002
or visit GEApplianceParts.com. In Canada call
1.800.561.3344.
1. Locate the water filter on the right-hand side of
the ice maker controls.
2. Remove the filter by rotating counterclockwise
from the lock to unlock position.
3. Remove the cover from the new water filter. Be
sure the O-rings are still in place after the cover
is removed.
4. Align the pin on the side of the filter with the
cutout channel in the filter housing and insert
filter.
5. Turn filter clockwise until it locks into the
housing. Ensure the alignment arrow on the
filter head is aligned with the locked symbol on
the control box housing.
NOTE: If the filter is not correctly locked into
place, the ice maker will not produce ice.
Reverse
Osmosis
system
IMPORTANT: The performance of the ice maker
may be affected when connected to a Reverse
Osmosis system. An RO system may also reduce
water pressure and affect the fill cycle, which is
dependent on time and flow. The reduced water
pressure may cause the reservoir not to fill and
flush properly during the ice making cycle.
The pressure of the water supply coming out
of a reverse osmosis system going to the water
inlet valve of the ice maker needs to be between
30 and 120 psi.
If a reverse osmosis water filtration system is
connected to your cold water supply, the water
pressure to the reverse osmosis system needs
to be a minimum of 40 psi. The reverse osmosis
system must provide 1 gal. of water per hour
to the ice maker for proper ice maker operation.
'RQRWXVHFRSSHUWXELQJZKHQWKHLFHPDNHULV
FRQQHFWHGWRD5HYHUVH2VPRVLVZDWHUV\VWHP
:DWHU¿OWHU
Locked
Unlocked
Cover
O-Rings
Alignment Pin
Alignment
Arrow
Unlock
symbol
Alignment Pin
Lock
symbol
12