GE ZDOD240 Refrigerator User Manual


 
Door gasket
For your
safety
The vinyl gasket may be cleaned with mild
soap and water, a baking soda solution or
a mild scouring powder. Rinse well.
After cleaning the door gasket, apply a
thin layer of paraffin wax or petroleum
jelly to the door gasket at the hinge side.
This helps keep the gasket from sticking
and bending out of shape.
Light bulb
replacement
Turn OFF or unplug the outdoor/indoor
refrigerator before replacing the light bulb.
To remove the light shield, push in the tab
on the left side of the shield and lower it.
Replace with a 15 watt appliance bulb.
In the event
of a power
failure
If power fails, you can maintain interior
temperature longer by keeping the door
closed. Open the door only when necessary
to avoid the loss of cold air.
Do not store or use gasoline or other
flammable vapors and liquids in the
vicinity of this or any other appliance.
Preparing
for vacation
For long vacations or absences,
always leave the unit running with the
temperature set at 45°F (7.2°C). This will
provide the greatest degree of protection
to your outdoor/indoor refrigerator. In
addition to leaving your unit turned on,
it is recommended that you follow the
below steps prior to long vacations. If you
cannot leave your unit turned on during
extended periods of non-use, be sure to
follow the below steps.
1. Remove all the contents from the unit.
2. Clean the outside and inside (see
instructions on the next page).
3. Place charcoal and baking soda inside
the unit. In conditions which are either
below 45°F (7.2°C) or high humidity,
use 4 lbs. baking soda. In all other
conditions, use 1 lb. baking soda.
4. Cover the unit with the Monogram
vinyl cover.
A vinyl cover accessory is available to
protect the outdoor/indoor refrigerator
during extended periods of non-use.
The durable vinyl exterior withstands the
elements and the soft felt lining helps
protect the stainless steel finish. There is
one that fits a built-in installation or one
for free-standing use. In addition to the
vinyl cover, an embroidered Monogram
polishing cloth is available. Use the
polishing cloth to keep the refrigerator’s
stainless steel finish clean.
ZBKTF – for free-standing installation
ZBKTB – for built-in installation
ZPOL – for Monogram polishing cloth
Call 800.626.2002 to order.
For shorter vacations, remove perishable
foods and leave controls at regular settings.
However, if the ambient temperature is
expected to drop below 45°F (7.2°C),
follow the same instructions as for long
vacations.
Preparing
to move
Secure all loose items such as shelves and
drawers by taping them securely in place
to prevent damage.
Be sure the outdoor/indoor refrigerator
stays in an upright position during moving.
Turn the outdoor/indoor refrigerator OFF or unplug the unit before cleaning.
Turn the outdoor/indoor refrigerator OFF by pressing the button on the control panel
a minimum of 3 seconds until the light and temperature display turn off.
12
Care and Cleaning
Outdoor/Indoor Refrigerator