GE ZET2P Convection Oven User Manual


 
34
Care and Cleaning
Wall Oven
Oven racks
The racks may remain in the oven during the
self-cleaning cycle without being damaged.
Periodically, after several self-clean cycles, the
oven racks may need to be lubricated using
the Graphite Lubrication shipped with your
wall oven. To order additional Graphite
Lubrication, call our National Parts Center
800.626.2002 and reference WB02T10303.
1 Remove rack from the oven. See the Full
extension oven racks section.
2 Fully extend the rack on a table or
countertop. Newspaper may be placed
underneath the rack for easy clean up.
3 If there is debris in the slide tracks, wipe
it away using a paper towel. NOTE: Any
graphite lubricant wiped away must be replaced.
4 Shake the graphite lubricant before opening
it. Starting with left slide mechanism of the
rack, place four (4) small drops of lubricant
on the two (2) bottom tracks of the slide
close to the bearing carriers.
5 Repeat for the right slide mechanism of
the rack.
6 Open and close the rack several times to
distribute the lubricant.
7 Replace the cap on the lubricant and shake
it again. Turn the rack over and repeat steps
3, 4, 5 and 6.
8 Close the rack, turn rack right-side-up and
place in the oven. See the Full extension oven
racks section.
9 Repeat above steps for each rack.
NOTE: Do not spray with Pam
®
or other lubricant
sprays.
Left side
Left side
Right side
Right side
Rack right-side-up
Rack right-side-up
Rack up-side-down
Rack up-side-down