Filter
Top Products
34
Step 1
Match Handle
Extrusion
to Panel
•Cut a piece of corrugated to use as a pad to protect
the panel finish. Additional material may be
required to protect flooring when drilling.
•Place custom panel on the pad, appearance side
down.
•Select handle extrusion for your model, left or right
side extrusion.
•Place extrusion against the handle side of the panel.
•Align the extrusion evenly with the top and bottom
of the panel.
•Tape the extrusion to the panel to prevent
movement.
•Center punch and drill 1/8″ pilot holes through the
holes in the extrusion and into the panel.
•Turn panel over. On the appearance side, use 9/32″
bit to enlarge clearance hole.
Step 2
Install
Standoffs
onto Handles
•Place a handle standoff on each attachment post
on the handle. Position the screw hole on the
standoff to point to the floor.
•Install set screws into the bottom of each standoff,
using the Allen wrench provided. The standoff
should be tight against the handle.
NOTE: Hole locations must be exact to accept handle
standoff and handle assembly.
Step 3
Install
Mounting
Screws
and Handles
•Start mounting screws through the extrusion and
just through the custom panel.
•Stand panel up on the hinge side and hold to
access the appearance side. Place handle against
mounting screws on the appearance side, drive top
screw from the back of the extrusion partially into
the standoff.
•Drive bottom screw partially into the standoff,
and then drive remaining screws partially into
standoffs. Alternate back to the top, driving screws
until the handle is tight against the door.
Step 4
Install
Assembled
Panels
It is best that 2 people perform this step.
•Place assembled panel onto the bottom door trim
with support bracket tabs inserted into slots.
•Push and hold the panel back against the steel
door with door handle extrusion flush to the
handle side of the door.
•Reinstall original screws into the door extrusion.
•Open the door fully to stop.
•Install screws at the top and hinge side.
Align Extrusion Even
With Panel
Back Side
Custom Panel
Screw
Allen Wrench
ZKHTRSS1 (For 3/4″ Panels)
Tubular Stainless Steel Handles