Filter
Top Products
Stud
Spacer
Block
Refrigerator
Cabinet
Door
37
Step 5
Install Center
Trim Strip
• Open doors fully.
• Starting at the top, press trim strip over inside case
trims of both products.
• Continue pressing trim until you reach the bottom
of the case trims. The trim will align with the top
and bottom of the case trim.
Case Trim
U-Shape
Trim
Step 6
Remove
Wire Fence
and
Switch Cover
• Remove 3 screws holding the wire fence on both
products. Retain fences and all screws.
Remove
3 Screws
Grill Base Cover
• Lift off grille base covers. Discard covers.
Step 4
Secure
Products
To Sides
NOTE: This step can be used
as an alternative to Step 2,
Anti-Tip bracket installation,
whenever brackets cannot
be used. Whenever possible,
perform this step for additional
anti-tip security.
OR
When using 1/2″ to 3/4″ thick side panels, the front
flange of the case trim is attached to the side panel.
• Open door to access case trim.
• Drill hole in trim slightly below the interior opening.
• Drive screw through the trim and into the side
panel.
• Follow the same procedure on the opposite outside
product trim.
If the product is installed between cabinets with no
side panels or into a custom enclosure, install a
spacer block as shown.
ZUG75 Trim Kit
Unified 3/4″ Custom Grille Panel Kit