Filter
Top Products
Controls and Features
Gloss Conopg Hood
Controls
NOTE: Avoid using food products that produce
flames under the range hood.
1 POWER ON/OFF. Press to activate (turn
on)/deactivate (turn off)the control buttons.
When the buttons are active (turned on), their
outer rings will be illuminated. When active
(turned on), the hood lights and fan will
automaticall U turn on at their last settings.
NOTES:
• Alwags deactivate {turn off) the buttons when
the hood is not in use.
• If both the LIGHT and FAN are setto OFF,the
buttons will automaticallu deactivate {turn off)
after 10 seconds.
2 LIGHT DECREASE ON/OFR Press to turn on
and dim the lights. It remembers the last light
level used, The buttons allow you to cycle
around to the desired setting. (There are four
light levels/settings and OFF.)
3 LIGHT INCREASE ON/OFF. Press to turn on
and brighten the lights. It remembers the last
light level used. The buttons allow Uou to cycle
around to the desired setting. (There are four
light levels/settings and OFF.)
4 Display. Shows the fan setting,
S FAN DECREASE ON/OFF. Press to turn on and
decrease fan settings, It remembers the last
fan level used. The buttons allow you to cycle
around to the desired setting. (Use to set the fan
speed to LOW, MED, HIGH, BOOSTor OFF.)
6 FAN INCREASE ON/OFF. Press to turn on and
increase fan settings. It remembers the last
fan level used. The buttons allow you to cycle
around to the desired setting. (Use to set the fan
speed to LOW, MED, HIGH, BOOSTor OFR)
BOOST--Provides five minutes at the maximum
fan setting and then automaticall U sets to HIGH
fan.
SENSOR FEATURE--The hood fan will
automatically turn on at the MED setting and
the display will show AUTO MODE ON if cooking
temperatures become too hot. The fan will stag
on for a minimum of 3 minutes and will then
turn off when temperatures cool to an
appropriate level.
1 2 3 4 5 6
LOCATE ON/OFF SWITCH. Grasp the filter
handle, press inward and then pull down.
Remove charcoal filter, if present. Reach into
the motor compartment and locate the
ON/OFF push-button switch on the side of the
motoE Press switch to OFF position.