GE Monogram 48 Refrigerator User Manual


 
NOTE: Before replacing the bulbs, review
the light bulb information and WARNING.
Replacing Type 2 bulbs in lamps located inside
the light shield at the top of the fresh food
compartment:
1. Set the Master Light switch to the OFF
position (see Using the Master Light switch)
and allow the lamps to cool.
2. If the Water Filter Cartridge is installed,
remove it and replace with the filter
bypass plug.
3. Holding the light shield with one hand,
rotate the support tabs until they clear the
front of the light shield. Then push back on
the light shield, lower the shield at the front
and take out.
4. Remove the 4 screws securing the light
housing to the ceiling. There are two screws
at the front and two at the back.
5. Lower the light housing at the front, then
pull it toward you so the tabs at the back of
the light housing come out of the slots on
the back wall. The lamp assemblies will
release from the holders.
6. Turn the lamp
protector to
access the bulb.
NOTE: Always follow bulb manufacturer’s
directions for handling and replacing bulbs.
7. Remove the bulb by holding the base and
pulling straight out. Replace with a new bulb
and replace the lamp protector.
WARNING – Lamp protectors
must be replaced or the heat from the bulb
could damage the refrigerator.
AVERTISSEMENT :
Vous devez remettre en place les écrans
protecteurs des ampoules pour ne pas
endommager votre réfrigérateur avec la
chaleur produite par les ampoules.
8. Holding up the light housing, place each
lamp assembly in its holder. Feed the
attached wires through the slots and tuck
the wires outside the side of the light
housing.
9. Insert the tabs on the back of the light
housing in the slots on the back wall.
Raise the light housing into position and
secure with the four screws.
10. Replace the light shield and rotate the
support tabs back out so they support the
front of the shield.
11. Remove the filter bypass plug and replace
with the Water Filter Cartridge. Reset the
Master Light switch to the ON position.
22
Type 2 bulb
replacement
Care and Cleaning
Built-In Refrigerators
Upper light
shield
Screws
Screws
Slots
Light housing
Support tabs