Filter
Top Products
Installation
Built - In Refrigerators
Leveling
This model has 4-point leveling. All 4
corners are supported by leveling legs.
The front wheels are non-adjustable; they
are only used for positioning the unit.
• To level the back of the unit, turn hex
nut located above the front wheels.
• To level the front of the unit,
use a 1
1
⁄
4
″ open end wrench and
adjust the leveling legs.
• Turn hex nut or front leveling
leg clockwise to raise the unit,
counter-clockwise to lower
the unit.
See the Installation Instructions
(Pub. No. 49-6473—36), (Pub. No. 49-
6462—42), (Pub. No. 49-6457—48) for
complete directions.
Refrigerator
location
Do not install refrigerator where
temperature will be below 60°F (16°C)
because it will not run often enough to
maintain proper temperatures.
Do install it on a floor strong enough to
support a fully loaded refrigerator.
Clearances
If the refrigerator is to be installed in a
corner, allow 2″ between the hinges of the
refrigerator and the wall to ensure a 90°
door opening capability.
No other clearances at top, sides, or back
are required.
20
Hex nut
Wheel
Leveling leg
INSTALLATION REQUIREMENTS
IMPORTANT…Please Read Carefully.