GE Monogram GCG1500P Trash Compactor User Manual


 
9
COMPACTOR CARE
Your new compactor is designed to give you many years of
dependable service. However, there are a few things you are
expected to do in order to properly maintain your compactor. This
section will tell you how to clean and care for your compactor.
Changing the Air Filter
It is recommended that you use the charcoal air filter in the filter
compartment.
To order the correct replacement charcoal filters, call the toll-free
number 1-800-626-2002 (U.S.), 1-800-661-1616 (Canada).
1. Insert fingertips in the air filter cover and pull until the side tabs
release. Then, lift the cover to release the bottom tabs.
2. Remove the air filter by pulling the top edge of the filter. The filter
should pull out easily. Throw away used filter.
3. To replace air filter, push the replacement filter into place.
4. Insert the bottom tabs of the air filter cover and push in until the
side tabs snap into place.
Cleaning
Before cleaning the compactor, turn the Key-Knob (or Key-Switch) to
the OFF & LOCK position and remove it.
NOTE: Any services other than those outlined in this section should
be performed by a designated service representative.
Cleaning Exterior Surfaces
1. Wash exterior surfaces (including stainless steel) with a clean
sponge or soft cloth and a mild detergent in warm water. Do not
use abrasive or harsh cleaners. Rinse and dry thoroughly with a
soft cloth.
2. Wipe up spills right away. Some foods can damage the finish if
left on the compactor surface.
Cleaning Inside the Drawer
NOTE: You may want to wear gloves since there may be bits of glass
in the drawer.
1. Remove the bag. See the “Removing a Filled Bag.”
2. Press down on the lever-action lock (or Side-Lock latch).
3. Hold the lever-action lock down and tilt the side of the drawer out
until the lock clears the drawer front.
NOTE: If desired, the drawer side can be removed by tilting it up,
then lifting it out.
4. Wash the interior of the drawer with a clean sponge or soft cloth
and a mild detergent in warm water. Rinse and dry thoroughly
with a soft cloth.
5. If the drawer side was removed, slide it back into the tilted
position.
6. Press the lever-action lock (or Side-Lock Latch) down while
pushing the drawer side to the upright position.
7. Latch the drawer side by pushing up the lever-action lock (or
Side-Lock Latch).
Cleaning Inside the Cabinet
NOTE: You may want to wear gloves since there may be bits of glass
in the cabinet.
1. Pull the drawer out until it stops.
NOTE: Look to see how the drawer rollers move in the tracks. It
will be easier to replace the drawer after you have finished
cleaning.
2. Lift the front of the drawer to clear the stops.
3. Grasp the drawer on the sides and pull it out the rest of the way.
Set the drawer down gently.
4. Vacuum the inside of the cabinet. Liquid spills or wet trash should
be cleaned up by hand, or by using a vacuum designed to pick
up liquids.