Filter
Top Products
6
Operating Instructions Safety InstructionsConsumer Support Troubleshooting Tips
About the dishwasher control panel. (For models without a sensor: EDW5000 Series,
GHDA450 Series, GLD4100 Series, GLD4200 Series, GLD4300 Series, GLD5500 Series, and GLD5800 Series)
You can locate your model number on the tub wall just inside the door.
Throughout this manual, features and appearance
may vary from your model.
Control Settings
Status Indicator Lights
The Status display tells you what’s happening while the dishwasher is in operation and may
flash, indicating a malfunction (see page 8). The lights will come ON indicating the sequence
of operation the dishwasher is in.
SANITIZED Displayed when cycle has met sanitization conditions. Light remains ON until door is opened.
CLEAN Displayed when a wash cycle is complete. The light stays ON as a reminder that the dishes are
clean until the door is opened or until another cycle is selected.
Cycles
The light above the selected pad will be ON to indicate which cycle has been selected.
SANI WASH 7.3 gal., 97 min.
This cycle raises the water temperature in the final rinse to sanitize your dishware. The cycle
length will vary depending on the temperature of your inlet water.
NOTE: The SANI-WASH cycle is monitored for sanitization requirements. If the cycle is
interrupted during or after the main wash portion or if the incoming water temperature is so
low that adequate water heating cannot be achieved, the sanitizing conditions may not be met.
In these cases, the sanitized light will not illuminate at the end of the cycle.
NOTE: NSF certified residential dishwashers are not intended for licensed food establishments.
POTS 8.5 gal., 89 min.
& PANS
This cycle is meant for heavily soiled dishes or cookware with dried-on or baked-on soils.
Everyday dishes are safe to be used in this cycle.
NORMAL WASH 5.9 gal., 56 min.
This cycle is for medium/heavily soiled dishes and glassware.
LIGHT WASH 6.1 gal., 36 min.
(on some models)
This cycle is for everyday dishes and glassware.
CHINA CRYSTAL 6.1 gal., 39 min.
(on some models)
This cycle is for lightly soiled china and crystal.
RINSE ONLY 1.2 gal., 6 min.
For rinsing partial loads that will be washed later. Do not use detergent with this cycle.
NOTE: Only the SANI-WASH cycle has been designed to meet the requirements of Section 6,
NSF 184 for soil removal and sanitization efficacy
.
1
1
3
4
2
2