Filter
Top Products
4
Operating Instructions Safety InstructionsConsumer Support Troubleshooting Tips
About the dishwasher control panel. (For models with sensor: EDW6000 Series,
GHDA650 Series, GLD6200 Series, GLD6300 Series, and GLD6500 Series)
You can locate your model number on the tub wall just inside the door.
Throughout this manual, features and appearance
may vary from your model.
Control Settings
Status Indicator Lights
The Status display tells you what’s happening while the dishwasher is in operation and may flash, indicating a
malfunction (see page 8). The lights will come ON indicating the sequence of operation the dishwasher is in.
SENSING Displayed while the sensor is measuring the amount of soil and temperature of water.
(on some models) The dishwasher will adjust the selected cycle to achieve optimal performance.
WASHING Displayed during prewash and main wash periods.
(on some models)
RINSING Displayed during rinse periods.
(on some models)
DRYING Displayed during HEATED DRY.
(on some models)
SANITIZED Displayed when cycle has met sanitization conditions. Light remains ON until door is opened.
CLEAN Displayed when a wash cycle is complete. The light stays ON as a reminder that the dishes are clean until the door is
relatched or until another cycle is selected.
Time Remaining Display (on some models)
During operation, the display shows the minutes remaining until the cycle is complete. The display may adjust
the remaining time while the sensing light is on. The time displayed at the start of each cycle may change from
the factory setting as the unit customizes itself to home use. During a delay start, the display will show hours of
time remaining until the cycle starts.
Cycles
The light above the selected pad will be ON to indicate which cycle has been selected.
This dishwasher is equipped with a dirt and temperature sensor. Cycle length and time will vary depending on the soil
level and temperature.
ANTI-BACTERIA Heavy 8.5 gal., 84 min.
or SANI WASH Medium 7.3 gal., 78 min.
Light 6.1 gal., 75 min.
This cycle raises the water temperature in the final rinse to sanitize your dishware. The cycle length will vary
depending on the temperature of your inlet water.
NOTE: The Anti-Bacteria cycle is monitored for sanitization requirements. If the cycle is interrupted during or
after the main wash portion or if the incoming water temperature is so low that adequate water heating cannot
be achieved, the sanitizing conditions may not be met. In these cases, the sanitized light will not illuminate at
the end of the cycle.
NOTE: NSF certified residential dishwashers are not intended for licensed food establishments.
POTS Heavy 10.9 gal., 102 min.
& PANS Medium 8.5 gal., 78 min.
Light 7.3 gal., 73 min.
This cycle is meant for heavily soiled dishes or cookware with dried-on or baked-on soils.
Everyday dishes are safe to be used in this cycle.
NORMAL WASH Heavy 8.5 gal., 65 min.
Medium 7.3 gal., 60 min.
Light 4.9 gal., 49 min.
This cycle is for medium/heavily soiled dishes and glassware
.
1
1
53
2
3
2
4