Filter
Top Products
How to Delay the Start of Cleaning (on some models)
Make sure the clock shows the correct
time of day.
Latch the door.
Touch the SELF CLEAN pad.
Using the + or – pads, enter the
desired clean time.
Touch the START TIME pad. The
earliest start time you can set will
appear in the display.
Using the + or – pads, enter the
time of day you want the clean cycle
to start.
Touch the START/ON pad.
The display will show the start time. It
will not be possible to unlatch the oven
door until the temperature drops below
the lock temperature.
The oven shuts off automatically when
the clean cycle is complete, and 0:00 will
flash in the display.
After a Clean Cycle
You may notice some white ash in the
oven. Wipe it up with a damp cloth after
the oven cools.
If white spots remain, remove them with a soap-
filled steel wool pad and rinse thoroughly with
a vinegar and water mixture.
These deposits are usually a salt
residue that cannot be removed by
the clean cycle.
If the oven is not clean after one clean
cycle, repeat the cycle.
■ You cannot set the oven for cooking
until the oven is cool enough for the
door to be unlatched.
■ While the oven is self-cleaning, you
can press the CLOCK pad to display
the time of day. To return to the
clean countdown, press the SELF
CLEAN pad.
■ Apply a small amount of vegetable oil
to a paper towel and wipe the edges of
the oven shelves with the paper towel.
Do not spray with Pam
®
or other
lubricant sprays.
20
Consumer Support Troubleshooting Tips Care and Cleaning Operating Instructions Safety Instructions
Using the self-cleaning oven.
To Stop a Clean Cycle
Touch the CLEAR/OFF pad.
Wait until the oven has cooled below the
locking temperature to unlatch the door.
You will not be able to open the door
right away unless the oven has cooled
below the locking temperature.