Filter
Top Products
Installation Instructions
5
STEP 1 MODEL ZFSB25
(GO TO STEP 1A FOR
MODEL ZFSB26)
MOVE REFRIGERATOR INDOORS
IMPORTANT: Door and passageways into
the installation location require a 31" min. opening. If
the opening is less than 31", the top cap and doors must
be removed.
NOTE: Skip this step if door removal is not required.
See instructions on next page, “To Move The
Refrigerator Indoors.”
REMOVE THE DOORS
The top cap must be removed to access hinges. It is best
to remove one door at a time.
A. Remove 2 screws on top and 2 screws at the back of
the top cap. Lift off top cap.
B. Open both doors. Remove the 2 toekick screws and
pull forward to remove.
C. Disconnect the water line coupler by pushing against
the collar on the left side. Disconnect wire harness.
D. Remove 2 screws holding top hinge to the case.
Carefully lift off door.
Follow the same procedure to remove the fresh food
door.
Hinge Screws
D
Water Line Coupler
Wire Harness
C
Toekick Screw
B
A
NOTE: To prevent damage, leave inside
packaging, door spacer and outside
protective wrap in place until the unit is
moved to the installation location.