Filter
Top Products
8
Control Panel
Dishwasher
3. Options
The light above the selected pad will be ON to indicate which option has been selected.
POWER For use with heavily soiled and/or dried-on, baked-on soils. This option
PRESOAK MUST be selected PRIOR to starting the cycle. This option adds
16 minutes to the cycle time.
SPEED DRY Shuts off the drying heat option. Dishes air dry naturally and energy is
OFF saved. You can prop the door open after the CLEAN light illuminates.
SPEED DRY Turns the heater on for fast drying. This cycle will extend the time ON to
ON your wash cycle by 23 minutes for the NORMAL cycle and 30 minutes for
the SANIWASH cycle. NOTE: Cannot be selected with RINSE & HOLD cycle.
LOCK
When the LOCK pad is touched twice within 3 seconds, all pads become
inoperative. You can lock the controls to prevent any selections from being made.
Or you can lock the controls after you have
started a cycle or selected DELAY
START so the cycle or DELAY START is not interrupted.
Children cannot accidentally start dishwasher by touching pads with this
option selected.
To unlock the dishwasher after it has been locked, touch the
LOCK
pad twice
within 3 seconds. The light above the
LOCK
pad will turn off.
DELAY START You can delay the start of a wash cycle for up to 8 hours. Press the DELAY
START pad to choose the number of hours you want to delay
the start of the
cycle. The machine will count down and start automatically
at the correct time.
Pressing the START/RESET button will cancel the DELAY START
selection. NOTE: If you forget to latch the door a reminder signal will
beep until you do so.
RESET To change a cycle after washing starts, touch the START/RESET pad
to cancel the cycle. After water is pumped out and the motor stops,
you can reprogram and restart the dishwasher. This will take
approximately 90 seconds.
4. Start
Close and latch the door. Touch the START/RESET pad to begin the cycle. Water fill begins and
approximately 40 seconds later the wash action begins.
NOTE: The dishwasher remembers your last cycle so you don’t have to reprogram each time.
When the dishwasher is loaded and the door latch is in the locked position, the control panel
lights will be on and display the last settings you selected.
If you do not want to change any of the settings, simply touch the START/RESET pad to begin
the cycle.
Also, if a power failure occurs, NORMAL and SPEED DRY will automatically be programmed.
Make any new selections and touch the START/RESET pad to begin the cycle.
5. Clean
This light is illuminated when a wash cycle is complete. The light will stay on until the door is opened.