Filter
Top Products
Care and Cleaning
Icemaker
Light bulb
replacement
The icemaker has a light bulb in the top of the
storage bin. To replace it, open the bin door
and follow these instructions:
1. Unplug the icemaker or disconnect power.
2. Remove the 3 screws that hold the cutter
grid cover in place. Reach behind the
control panel and pull the light bulb down.
3. Replace with a 12-volt wedge base-type bulb
(automotive #917). Locate the light bulb
receptacle at the top behind the control
panel. Align the flat edge of the light bulb
with the receptacle and snap the bulb
into place.
4. Replace the cutter grid cover with the
3 screws.
5. Plug in the icemaker or reconnect power.
Vacation
and moving
To shut down the icemaker:
1. Unplug the icemaker or disconnect power.
2. Remove all ice from the storage bin.
3. Shut off the water supply.
4. Remove the 2 screws in the lower access
panel and the 2 screws from the base grille
area of the front panel support. Pull forward
to remove the lower access panel.
5. Disconnect the inlet and outlet lines to
water valve. Allow these lines to drain and
then reconnect to the valve.
6. Replace the lower access panel and screws.
Drain water from water reservoir by
removing the drain cap. Also, remove water
from drain line. Leave the door open
to allow the icemaker and water reservoir
to dry out completely.
7. Before using again, clean the icemaker
and storage bin.
IMPORTANT: Every time the icemaker is
turned off, you MUST clean the icemaker
system with the Nickel Safe Ice Machine
Cleaner. See Care and Cleaning—Icemaker
system section for instructions.
8. Plug in the icemaker or reconnect power.
NOTE: All components of the icemaker are
permanently lubricated at the factory. They
should not require any additional oiling
throughout the normal life of the machine.
Reverse
Osmosis
system
IMPORTANT: The performance of the
icemaker may be affected when connected to
a Reverse Osmosis system. An RO system may
also reduce water pressure and affect the fill
cycle, which is dependent on time and flow.
The reduced water pressure (less than 20 psi)
may cause the reservoir not to fill and flush
properly during the ice making cycle.
Do not use copper tubing when the icemaker is
connected to a Reverse Osmosis water system.
13