Filter
Top Products
12
Reversing the Door Swing
Wine Chiller
To reverse
the door
Parts included:
1. Top left case hinge
2. Bottom left case hinge
3. Left and right side decorative
hinge cover
4. Decorative hinge screw hole cover
5. Torx
®
driver bit
Tools required:
1. Phillips screwdriver
2. Electric drill
To remove the door:
1. Flatten the shipping carton to use as
a pad.
2. Remove the 2 screws and the toekick.
Set aside the screws and toekick for final
installation.
3. Use the supplied Torx
®
bit and electric drill
to remove the 3 screws holding the top
case hinge. Lift off the hinge. (Screws will
be used to install the new hinge.)
4. Lift the door off the bottom case hinge.
5. Remove the bottom case hinge pin and
bracket.
Rotate the door:
The handle will be on the right side of the
door; hinges will be installed on the left side
of the case.
1. Remove the door stop and cam riser on the
original bottom right side of the door.
2. Remove the fill plug on the top right side of
the door.
3. Turn the door over and reinstall the fill plug
on the new left side.
To reinstall the door:
1. Install the original door stop and cam riser
onto the bottom left side of the door.
2. Install the new supplied bottom case hinge
pin and bracket onto bottom left side.
3. Place the door onto the bottom case
hinge.
4. Install the supplied left-hand top case
hinge with the 3 original screws.
5. Select the hinge cover marked with
an “L”.
6. Peel backing off the tape inside the
decorative hinge cover.
7. Press and snap the
hinge cover into place.
8. Snap the screw hole
cover into place on
the opposite side.
Important: Check to be sure screws are tight
and that the door is straight and does not
sag. The door should swing freely.
NOTE: See Installation Instructions to apply
hinge cover and screw hole cover.
Position nameplate:
Apply the Monogram nameplate on
the door using the template included
in the installation instructions.
Remove
Top Hinge
Remove
Hinge
Install
3 Hinge
Screws
Door Stop
and Cam Riser
Hinge
Pin and
Bracket
Install Covers