Filter
Top Products
14
Cabinetry Modification Suggestions
30" Built-In Convection Ovens
Cut rail
for filler
panel
Cut the rail out of finished material:
• The width should match cabinet opening width.
• The height of the top rail should be enough to
securely attach the rail to the appearance panel,
plus 1/4" oven trim overlap.
• The height of the bottom rail should be enough to
securely attach the rail to the appearance panel,
plus 7/8" oven trim overlap.
• The height of both the top and bottom rails should
be adjusted depending upon the height of the gap
to be filled or to enhance appearance.
Use drawer fronts for appearance panels or cut
finished material and finish raw edges.
• The appearance panel width should match drawer
fronts or doors.
• Make the appearance panel appropriate height to
fill the gap above or below the oven, allowing for
reveals and overlaps to match existing drawers or
doors.
Cut appearance
panel
Determine
location
of cleats
• To find the exact position of the cleats, place the
appearance panel onto the cabinet in desired
position and align to match the other drawers and
doors.
• Use a pencil to mark the back side of the panel
where it meets the cabinet corners.