GE Monogram ZET857DYSB Oven User Manual


 
Before you begin—Read these instructions completely and carefully.
IMPORTANT: Save these instructions for local inspector’s use.
IMPORTANT: OBSERVE ALL GOVERNING CODES AND ORDINANCES.
NOTE TO INSTALLER: Be sure to leave these instructions with the
Consumer.
NOTE TO CONSUMER: Keep these instructions with your Use and Care
Book for future reference.
This appliance must be properly grounded. See “Electrical Supply”, page 9.
CAUTION
WARNING
If you have questions concerning the installa-
tion of this product, call the GE Answer
Center
®
Consumer Information Service at
800.626.2000, 24 hours a day, 7 days a week.
If you received a damaged oven, you should
contact your dealer.
Proper installation is the responsibility of the
installer. Product failure due to improper installation
is not covered under the GE Appliance Warranty. See
the Use & Care Guide for warranty information.
CAUTION:
• This oven should be installed by a qualified
installer or service technician.
• Never use the oven for warming or heating a
room. Prolonged use of the oven without
adequate ventilation can be hazardous.
Check with local utilities for electrical codes which
apply in your area. Local codes vary. Installation,
electrical connections and grounding must comply
with applicable codes. In the absence of local codes,
the oven should be installed in accordance with
National Electrical Code ANSI/NFPA 70-1990.
Design Information
Models Available..................................................................................................................................3
Dimensions and Clearances ...............................................................................................................3
Cabinet Style Options .........................................................................................................................4
Cabinetry
Tools and Materials required .............................................................................................................5
Framed Cabinet, Double Oven ..........................................................................................................5
Framed Cabinet, Single Oven ............................................................................................................6
Frameless Cabinets ..............................................................................................................................7
Installation
Provide Oven Supports .......................................................................................................................8
Install Oven Supports.......................................................................................................................... 8
Step 1: Remove the Packaging............................................................................................................8
Electrical Supply ..................................................................................................................................9
Step 2: Install Junction Box ................................................................................................................ 9
208V Electrical Supply.......................................................................................................................10
Step 3: Remove Oven Doors .............................................................................................................11
Step 4: Rotate Cable through Cutout...............................................................................................11
Step 5: Secure Oven to Cabinet ........................................................................................................11
Step 6: Replace the Oven Door ........................................................................................................12
Step 7: Connect Electrical.................................................................................................................12
Cabinetry Modification Suggestions
Determine Need for Filler Panels.....................................................................................................13
Filler Panel Construction ..................................................................................................................13
Cut Rail for Filler Panel ....................................................................................................................14
Cut Appearance Panel ......................................................................................................................14
Determine Location of Cleats...........................................................................................................14
Cut and Secure Cleats to Filler Panel...............................................................................................15
Secure Rail to Appearance Panel .....................................................................................................15
Secure Assembled Filler Panel to Cabinet .......................................................................................15
Contents
2