Filter
Top Products
Installation Instructions
5
STEP 1 MODEL ZFSB25
(GO TO STEP 1A FOR MODEL ZFSB23)
MOVE REFRIGERATOR INDOORS
IMPORTANT: Doors and passageways into
the installation location require a 31" min. opening. If the
opening is less than 31", the top cap and doors must be
removed.
NOTE: Skip this step if door removal is not required.
See instructions on page 7, “To Move The Refrigerator
Indoors.”
REMOVE THE DOORS
The top cap must be removed to access hinges. It is best
t
o remove one door at a time.
A. Remove 2 screws on top and 2 screws at the back of
the top cap. Lift off top cap.
B. Open both doors. Remove the 2 toekick screws and pull
forward to remove.
C. Disconnect the water line coupler by pushing against
the collar on the left side. Disconnect wire harness.
D. Remove 2 screws holding top hinge to the case.
Carefully lift off door.
Follow the same procedure to remove the fresh food door.
Hinge Screws
D
Water Line Coupler
Wire Harness
C
Toekick Screw
B
A
NOTE: To prevent damage, leave inside
packaging, door spacer and outside
protective wrap in place until the unit
is moved to the installation location.