Filter
Top Products
Glass Cooktop Surface Cleaning
Gas Cooktop
17
Burned-on
residue
WARNING: DAMAGE to your glass
surface may occur if you use scrub pads other
than the pad included with your cooktop.
AVERTISSEMENT :
Vous pouvez ENDOMMAGER votre surface
en vitrocéramique si vous utilisez des éponges
de récurage autres que celles comprises avec
votre appareil.
1. Allow the cooktop to cool.
2. Remove the burner grates. Spread a few
drops of CERAMA BRYTE
®
Ceramic Cooktop
Cleaner on the entire burned residue area.
3. Using the included CERAMA BRYTE
®
Cleaning Pad for Ceramic Cooktops, rub the
residue area, applying pressure as needed.
4. If any residue remains, repeat the steps listed
above as needed.
5. For additional protection, after all residue
has been removed, polish the entire surface
with CERAMA BRYTE
®
Ceramic Cooktop
Cleaner and a paper towel.
Normal daily
use cleaning
ONLY use CERAMA BRYTE
®
Ceramic Cooktop
Cleaner on the glass cooktop. Other creams may
not be as effective.
To maintain and protect the surface of your glass
cooktop, follow these steps:
1. Before using the cooktop for the first time,
remove the burner grates and clean the
cooktop with CERAMA BRYTE
®
Ceramic
Cooktop Cleaner. This helps protect the top
and makes cleanup easier.
2. Daily use of CERAMA BRYTE
®
Ceramic
Cooktop Cleaner will help keep the cooktop
looking new.
3. Shake the cleaning cream well. Apply a few
drops of CERAMA BRYTE
®
Ceramic Cooktop
Cleaner directly to the cooktop.
4. Use a paper towel or CERAMA BRYTE
®
Cleaning Pad for Ceramic Cooktops to clean
the entire cooktop surface.
5. Use a dry cloth or paper towel to remove all
cleaning residue. No need to rinse.
NOTE: It is very important that you DO NOT heat
the cooktop until it has been cleaned thoroughly.
Clean your cooktop after each
spill. Use CERAMA BRYTE
®
Ceramic Cooktop Cleaner.
Use a CERAMA BRYTE
®
Cleaning
Pad for Ceramic Cooktops.
Heavy,
burned-on
residue
1. Allow the cooktop to cool.
2. Remove the burner grates. Use a single-edge
razor blade scraper at approximately a 45°
angle against the glass surface and scrape
the soil. It will be necessary to apply pressure
to the razor scraper in order to remove the
residue.
3. After scraping with the razor scraper, spread
a few drops of CERAMA BRYTE
®
Ceramic
Cooktop Cleaner on the entire burned residue
area. Use the CERAMA BRYTE
®
Cleaning Pad
to remove any remaining residue.
4. For additional protection, after all residue
has been removed, polish the entire surface
with CERAMA BRYTE
®
Ceramic Cooktop
Cleaner and a paper towel.
The CERAMA BRYTE
®
Ceramic Cooktop
Scraper and all recommended supplies are
available through our Parts Center. See
instructions under “To Order Parts” section
on next page.
NOTE: Do not use a dull or nicked blade.