Filter
Top Products
33
Before you
begin:
Right hand door swing models are illustrated in these
instructions. Follow these instructions for left hand
models.
This kit provides for the installation of a Tubular
Stainless Steel handle on a 3/4" thick decorator door
panel. The door extrusions allows the custom handle
to be secured to the door structure, rather than to the
custom panel.
• Select the extrusion for your model, discard other
extrusion.
Tools and materials required:
• #2 Phillips screwdriver
• Drill and 1/8", 9/32" bits
• Custom door panel
• Safety glasses
• Center punch
• Masking tape
• Hammer
• Pencil
Parts List:
A. Handle extrusion (for left hand models)
B. Handle extrusion (for right hand models)
C. Stainless tubular handle
D. 4 Handle standoffs
E. 6 Screws for handle standoffs
(4 required, 2 extra)
F. 6 Set screws (4 required, 2 extra)
G. 3/32" Allen wrench for set screws
This kit must be used in combination with ZKTR36RH or
ZKTR36LH, trim kit.
NOTE: It is best that 2 people install this kit.
• The 3/4" custom panel must be routed to accommodate
the handle extrusion. Rout the panel as illustrated,
1/4" deep, and 1-13/16" wide, top to bottom on the
handle side.
• Follow the instructions in the ZKTR36RH (or ZKTR36LH)
to install trim onto the door. Discard the handle
supplied with that kit.
• Continue the instructions in the ZKTR36RH (or
ZKTR36LH) trim kit to install support brackets to
the bottom of the panel.
Kit
Contents
IMPORTANT: Optional final appearance depends on
careful routing depth. Do not exceed 1/4" routing depth.
1-13/16"
Back Side
Handle Side
Custom Panel
1/4" Max.
A
B
D
E
G
F
C
ZKHTRSS1 (For 3/4" Panels)
Tubular Stainless Steel Handles