GE Monogram ZSC2000CWW Oven User Manual


 
Monogram.
Specification Created 4/00
ZSC2000CWW - GE Monogram Built-In Advantium
Oven
Dimensions (in inches)
• These ovens may be installed directly into a wall
or wall oven cabinetry, 30" minimum width.
• The front surface of the oven will be nearly flush
with surrounding cabinetry doors.
• This oven can be installed over any GE single
electric built-in oven or a single GE electric built-in
warming drawer.
• This oven must be installed at least 36" above
the floor.
IMPORTANT: This oven is not approved for use
above another built-in Speedcook oven, side by
side or under the countertop installations.
• For personal safety, this oven cannot be installed
in a cabinet arrangement such as an island or
peninsula.
• Cabinets installed adjacent to wall ovens must
have an adhesion spec of at least 194°F tempera-
ture rating.
• Allow for clearance to adjacent corners, walls,
drawers, etc.
29-25/32"
15"
(Recessed
Portion)
21-7/8"
15-27/32"*
28-7/16"
R
Listed by
Underwriters
Laboratories
For answers to your Monogram,
®
GE Profile Performance Series,
GE Profile
or GE appliance questions, call
GE Answer Center
®
service, 800.626.2000.
27/32"
14-1/8"
15/32"
27/32"
20-27/32"
11/16"
7/8"
13"
9/16"
Single Speedcook Installation
Product rating is 120/208 or 120/240 volt, 60 Hz, 30 Amps. This product must be connected to
a supply circuit of the proper voltage and frequency and protected by a time delay fuse or cir-
cuit breaker. The power supply should be brought to a separate 30 ampere branch circuit.
Wire size must conform to the requirements of the National Electric Code or the prevailing
local code.
Combined Speedcook and Wall Oven Installation:
When installed in combination with a GE single wall oven, use separate electrical
junction boxes,
OR,
Install a single junction box connected to 50 amp. supply circuit or properly rated
supply circuit.
Refer to single oven installation instructions for electrical requirements of
that product.
These connections must be made by a qualified electrician. All electrical
connections must meet National Electrical code or prevailing local codes.
Combined Speedcook and Warming Drawer installation:
When installing the Speedcook oven over a GE electric warming drawer, a separate
120V, 60Hz, properly grounded receptacle must be installed. See instructions packed
with the warming drawer.
Electrical Requirements
Installation Requirements
*Excludes Handle