Filter
Top Products
Monogram.
™
ZSC2000CWW - GE Monogram Built-In Advantium
™
Oven
36-3/4" Min.
Required
30"
19"
Min
Construct Solid
Bottom Min. 3/8"
Plywood
Supported by
2 x 4 or 1 x 2
Runners, all
Four Sides
28-1/2"
21"
36-3/4" Min.
30"
24"
Min.
Construct Solid
Bottom Min. 3/8"
Plywood
Supported by
2 x 4 or 1 x 2
Runners, all
Four Sides
2" Min.
Install 2 x 4
or 2 x 2
Runners or
Solid Bottom,
Must Support
100 lbs.
28-1/2"
21"
9-1/4"
*45-1/4"
30"
24"
Min.
Construct Solid
Bottom Min. 3/8"
Plywood
Supported by
2 x 4 or 1 x 2
Runners, all
Four Sides
2" Min.
Per Oven
Requirement
28-1/2"
21"
Single Speedcook Installation
Order a 30" wide single oven cabinet or cut the
opening in a wall to dimensions shown.
The rough opening must be:
• Depth - 19" Min.
• Width - 28-1/2" Min.
• Height - 21" Min.
• 36-3/4" from the floor to the cutout is required.
• These ovens require 3/4" overlap on each
side, top and bottom of the cutout.
• Oven overlaps will conceal cut edges on all
sides of the opening.
Specification Created 4/00
R
Listed by
Underwriters
Laboratories
For answers to your Monogram,
®
GE Profile Performance Series,
™
GE Profile
™
or GE appliance questions, call
GE Answer Center
®
service, 800.626.2000.
Note: Additional clearance between the
cutouts may be required. Check to be sure
the oven supports above the Warming
Drawer location does not obstruct the
required interior 23-1/2” depth and 9-1/4”
height. See installation instructions for
details.
Speedcook Oven Installation above a
GE Built-In Wall Oven
Speedcook Oven Installation above a
GE Warming Drawer