Filter
Top Products
7
Care and Cleaning
Stainless Steel Hood
For your
safety
Pour votre
securité
Before servicing or cleaning unit, switch power
off at service panel and lock the service
disconnecting means to prevent power from
being switched on accidentally. When the
service disconnecting means cannot be locked,
securely fasten a prominent warning device,
such as a tag, to the service panel.
Avant de réparer ou de nettoyer votre appareil,
débranchez le courant au niveau du panneau
de service et verrouillez les mécanismes de
débranchement de service pour éviter tout
branchement accidentel au courant. Si vous
ne pouvez pas verrouiller les mécanismes
de débranchement de service, attachez
soigneusement un avertissement bien visible,
comme une étiquette, au panneau de service.
Light bulbs
To change the light bulbs:
1. Remove the trim ring by turning it
counterclockwise.
2. Grasp the bulb on the edges and
pull it straight out.
3. Replace with the same size bulb.
These 12 volt, 20 watt halogen bulbs
are available at specialty lighting stores.
Ask for GE bulb or equivalent:
Q20MR16/C/CG40–BAB.
Metal
grease
filter
Clean
filter
light
Clean the grease filter after 30 hours of “on” time.
A red signal light will alert you when 30 hours
has passed.
Remove the grease filters and wash them
either by hand or in the dishwasher using
non-abrasive soap.
To clean, swish the filters in hot soapy water
or wash them in the dishwasher. Do not use
abrasive cleansers.
Replace the filters and make sure that they are
correctly seated in the filter channels. Adjust as
necessary until the red signal light stops blinking.
Hood
surfaces
Do not use a steel wool pad; it will scratch
the surface.
To clean the stainless steel surface, use warm
sudsy water or a stainless steel cleaner or polish.
Always wipe the surface in the direction of the
grain. Follow the cleaner instructions for
cleaning the stainless steel surface.
To inquire about purchasing stainless steel
appliance cleaner or polish, or to find the location
of a dealer nearest you, please call our toll-free
number:
National Parts Center 1.800.626.2002
ge.com
NOTE: To remove filters,
push them back and
down using the knob.
Front
For proper operation, make
sure the filters are securely
seated into the channels.
On some models, the lights are
located on the front and back,
on the underside of the hood.
On some models, the lights
are located on the sides,
on the underside of the hood.