Filter
Top Products
The Problem Solver
Outdoor Range Top Burners
12
Questions?
Use this
problem
solver!
PROBLEM POSSIBLE CAUSE
BURNER WON’T • Remove the burner grate. With the control knob in the OFF position,
LIGHT WHEN THE watch the electrode while turning the igniter knob. You should see
PUSH BUTTON a spark jump inside the electrode cap.
IGNITER KNOB
• Use a match to light the burner.
IS TURNED
• Visually check the electrode and wire while turning the igniter knob.
The only place a spark should appear is at the electrode tip. If the
electrode or wire leaks voltage, remove and replace.
• Purge the gas line of any air.
• Check the orifice for blockage.
• Inspect the igniter tip to make sure it is clean and free from debris.
Clean the area. Readjust for 1/8″ gap.
BURNER FLAME IS • Check the burner inlet for obstructions.
YELLOW OR ORANGE
• Check the air shutter for proper adjustment.
IN CONJUNCTION
• Do not place the range top burners in a dusty area.
WITH THE ODOR
OF GAS
LOW HEAT WITH • Inspect the fuel hose to ensure it is not bent or kinked.
CONTROL KNOB IN
• Adequate gas supply may not be available. Check to make sure there
THE HI POSITION
is gas in the LP tank.
• The burner or burner orifice may need cleaning.
• The air shutter may need adjustment.