Filter
Top Products
Page 10
MANUAL SLICER OPERATION
1. With slicer off, pull the food chute completely towards you and place the food product on the food
chute. Slice only boneless, unfrozen product with the slicer. Use the end weight to hold the food
product in place. If the end weight is not needed, it may be stored out of the way by swinging it back
behind the food chute and locking it on the retaining pin.
2. Make sure all knobs are tightened prior to using the slicer.
3. Rotate slice thickness dial counterclockwise to desired slice thickness. After slicing is complete,
always turn slice thickness dial completely clockwise to close slicer table.
4. Turn slicer on by pulling the on/off tab towards you. The power indicator light will illuminate.
DO NOT hold the food product with your hand. Never put you hand on or around food
chute when slicer is on. The food chute handle is the only part of the slicer you should
touch while slicing.
5. Use the food chute handle to manually push the food chute back and forth. The food chute handle
is the only part of the slicer you should touch while slicing. Do not catch slices with your hand. Let
slices drop on paper covered receiving area.
If a product needs to be adjusted during slicing, ALWAYS pull the food chute all the way
towards you. Turn off slicer, and close slicer table prior to adjusting the product and the
end weight.
6. After the last slice stroke, pull the food chute all the way towards you. Turn the slicer off by pushing
the on/off tab inward. The power indicator light will go out. Always turn slice thickness dial
completely clockwise to close the slicer table.
7. Now you can load and unload food product from the food chute.
MANUAL USE OF AUTOMATIC SLICER
ALWAYS make sure the auto engage lever is in the “Manual”
position before turning slicer on (Fig. 10-1).
1. Automatic slicers can be used manually when desired.
2. When manually operating an automatic slicer the auto engage lever
MUST be in the “Manual” position before turning the slicer on. The
lever should not be moved out of the “Manual” position at any time
during use.
3. Turn the slicer on by pressing the start button.
OPERATING INSTRUCTIONS
Figure 10-1
Auto Engage Lever