Globe SP40P Mixer User Manual


 
Page 8
Operating Instructions
ATTACHING THE AGITATOR TO THE MIXER (i.e., Beater, Hook, Whip)
NOTE: It is easier to install the agitator prior to adding the ingredients into the bowl.
1. Rotate the bowl guard to the left so it rests in the open position (see g 8-1).
Excessive force used to open and close the bowl guard may damage the
spring lock and bowl guard microswitch, and will void the warranty.
2. Slide the agitator slowly upwards onto the planetary shaft tting the shaft pin through the
slot in the agitator (see g 8-2).
3. Rotate the agitator clockwise to secure it onto the planetary shaft.
MIXING INGREDIENTS
Follow the capacity chart located on page 13 in this manual.
Overloading or not following this chart will damage the mixer and void
the warranty.
Agitators should always rotate in a clockwise direction around the bowl. If the agitator moves
counterclockwise, contact a licensed electrician immediately to remedy
incorrect wiring.
IMPORTANT: Make sure the speed control lever is on the rst (1) speed.
1. Add the appropriate mixing ingredients into the bowl.
2. Lift completely up on the bowl lift lever until the bowl locks into position. On the
SP40P and SP60P rotate the bowl lift wheel clockwise until the bowl is all the way
up into position. For the SP62P and SP80PL press the up arrow (blue button) until the
bowl is up into position.
3. Rotate the bowl guard to the right so it locks into the closed position (see g 8-3).
A clicking sound will be heard.
NOTE: The mixer will not start if the bowl guard is open or the bowl is in the lowered position.
4. Set the timer for the appropriate mixing time or set the mixer for non-timed operation.
a. Timed Operation: Turn the timer knob in a clockwise direction at least ve minutes past “0” to the desired
time. NOTE: To set the time for less than ve minutes turn the timer knob clockwise to six then
counterclockwise back to the desired time.
b. Non-Timed Operation: Turn the timer knob in a counterclockwise direction to the green “on” position.
NOTE: Heavy loads should not be mixed longer than fteen minutes at this setting without an equal
amount of rest time. Failure to adhere to these instructions may cause the mixer to automatically shut off
due to overloading.
Fig. 8-1
Fig. 8-2
Fig. 8-3