Filter
Top Products
Parts Drawing
Parts List
Hopper Kit Instructions
Initial Setup
1. Follow Pressure Relief Procedure on page 1.
2. Remove fitting from bottom of pump.
3. Apply sealant to nipple (5). Assemble to female fitting
(6) and female fitting (4) and tighten.
4. Apply sealant to male fitting (3) and tighten to hopper
(1).
5. Apply sealant to bottom of pump and assemble
subassembly from step 3.
6. Loosely install bracket (7) with two screws (8) into
pump bracket.
7. Install hopper assembly (1) into subassembly from
step 4 and tighten quick disconnect fitting (4).
8. Push bracket (7) up to secure hopper.
9. Tighten screws (8) to 30-35 ft-lb.
Removal
1. Loosen quick disconnect fitting (4).
2. Remove hopper.
Installation
1. Set hopper on bracket (7).
2. Rotate hopper into quick disconnect fitting (4).
3. Tighten quick disconnect fitting (4).
Ref. Part Description Qty.
1 16U536 HOPPER, weldment
1
2 16U537 COVER, weldment
1
3 120307 FITTING, hose adapter, male
1
4 120308 FITTING, hose adapter, female
1
5 108209 NIPPLE, pipe
1
6 126939 FITTING, elbow, 90, female, reducing
1
7 16U538 BRACKET, mount, hopper
1
8 111195 SCREW, cap, flnghd
2
10 110110 SEALANT pipe, sst
1
8
2
3
4
5
6
7
8
1
ti21000a
All written and visual data contained in this document reflects the latest product information available at the time of publication.
Graco reserves the right to make changes at any time without notice.
This manual contains English. MM 332234
Graco Headquarters: Minneapolis
International Offices: Belgium, China, Japan, Korea
GRACO INC. AND SUBSIDIARIES • P.O. BOX 1441 • MINNEAPOLIS MN 55440-1441 • USA
Copyright 2012, Graco Inc. All Graco manufacturing locations are registered to ISO 9001.
www.graco.com
Revision A - January 2013