Filter
Top Products
1. Turn off the power to the unit.
2. Let the stove cool if it has been operating.
3. Turn the stove so you are facing the back of the stove.
4. Look for the access plate with the gold printing on it.
5. Remove the two (2) screws holding the bulb slides. These slides allow you to pull each
bulb to the access panel opening, making it easier to change the light bulb.
6. Remove the four (4) screws holding the access plate in position. Once you have removed
the four (4) screws, remove the access plate. You can now see and access the two (2)
25 watt chandelier bulbs under the ember bed.
7. Pull the bulb slides towards you until you can easily reach the bulbs.
8. Remove each light bulb by unscrewing them out of the bases, turning them towards
you. You can use one hand to hold the light socket in place, if required.
9. Install the new light bulbs by turning each light bulb into the base away from you.
You can use one hand to hold the light socket in place, if required.
10. Push the bulb slides back into position.
11. Replace the access plate by pushing the plate up against the stove back,
and inserting the four (4) screws.
12. Insert and tighten the 2 screws holding the bulb slides in place.
13. Turn the stove back so you are facing the front of the stove.
14. Turn the power on and enjoy the flame effect.
OPERATING INSTRUCTIONS
After reading these instructions confirm that all controls on the stove are in the off position.
Plug the stove into a 15 amp, 120 volt outlet.
All controls and switches are on the front panel of the stove located inside the right hand
door.
Flame – to enjoy the flame just press the power switch to the on position.
Flame Brightness control – you can adjust the intensity of the
flame by moving the dial from the minimum position to the
maximum position. Select the brightness that you prefer. This
feature will only work if the power switch is in the on position.
MIN Heat (700) – to obtain low heat just press the heat switch
marked 700 to the on position.
MAX Heat (1400) – to obtain high heat you must ensure the
thermostat dial is in the maximum position and then press the
700w and the 1400w switches to the on position. If you move
the thermostat to the minimum position this High Heat Switch will be automatically shut off.
CLEANING YOUR STOVE
Before you clean your stove, please ensure the unit has been turned off, unplugged from the power source and the
unit has cooled.
To clean the doors:
Remove dust with a clean, dry, soft cloth that will not scratch the surface of the door.
Remove finger prints or other “oily” marks with a clean, damp, soft cloth.
To clean metal, and other painted parts:
Remove any marks on any of these surfaces with a clean, damp, soft cloth that will not scratch these surfaces.
DO NOT USE abrasive cleansers or spray liquids on any surface of this stove.
5
6
7
8