Greenway Home Products VWD2636W-1 Water Dispenser User Manual


 
Cleaning Your Water Dispenser
IMPORTANT: Make sure you turn the power switch to the OFF position and unplug the dispenser
before performing any of the following cleaning procedures.
Cleaning the Outside of the Water Dispenser
The outside of the dispenser can be wiped clean with a water dispenser cleaning solution or a mild
soap and water mixture. Never use harsh chemicals or abrasive cleaners. Rinse thoroughly with
clean water and then dry surfaces.
Cleaning the Drip Tray
To remove, take the grill off the tray and firmly lift the tray up,
dislodging it from the guides. Drain and clean.
The drip tray should be emptied and cleaned regularly to remove
spotting and any mineral deposits. Clean with a water dispenser
cleaning solution or a mild soap and water mixture. For tough deposits,
add vinegar and let it soak until the deposits come loose. Then wash,
rinse and dry thoroughly (not dishwasher safe).
To replace, put the grill back on the tray and slide the tray onto the guides.
Draining the Reservoirs
Drain the reservoirs before and after cleaning, when going on long
vacations or if not using the dispenser for long periods of time.
IMPORTANT! Turn the power switch to the OFF position and
unplug the dispenser before performing this procedure. Dispense
hot water until temperature drops to a safe level to avoid the risk of
scalding.
1. Remove the water bottle.
2. Press/hold all dispensing buttons until water stops flowing from
the faucet.
3. Place the unit over the sink and drain both internal reservoirs by
removing the spring clamps and caps from both drain outlets
located on the bottom of the unit.
4. When the water completely stops flowing, replace the drain
caps and spring clamps.
IMPORTANT: Drain the water into a container and/or sink,
not the drip tray.
6
Hot Cool
bottom of dispenser