Filter
Top Products
5
Cleaning the Drip Tray
To remove, take the grill off the tray and firmly lift the tray up, dislodging it
from the guides. Drain and clean.
The drip tray should be emptied and cleaned regularly to remove spotting
and any mineral deposits. Clean with water dispenser cleaning solution or
a mild soap and water. For tough deposits, add vinegar and let it soak
until the deposits come loose. Then wash, rinse and dry thoroughly.
To replace, put the grill back on the tray and slide the tray onto the guides.
Childproof Safety Feature
To prevent hot water from accidentally harming a child, the hot
water dispenser tap has a safety mechanism. Firmly squeeze the
red tap and press downward to dispense hot water.
DANGER: The hot water is heated to approximately 194˚ F / 90˚ C.
Temperatures above 125˚ F / 52˚ C can cause severe burns from scalding.
DO NOT ALLOW CHILDREN TO USE THE HOT WATER DISPENSING
BUTTON WITHOUT PROPER AND DIRECT SUPERVISION.
CLEANING AND MAINTENANCE
Like most appliances, your new water dispenser requires periodic maintenance to operate efficiently.
Your water dispenser must be cleaned every 4 months. Failure to maintain your dispenser will void
your warranty.
Cleaning Your Water Dispenser
IMPORTANT: Make sure you turn the power switch to the OFF position and unplug the dispenser
before performing any of the following cleaning procedures.
Cleaning the Outside of the Water Dispenser
The outside of the dispenser can be wiped clean with a water dispenser cleaning solution or a mild
soap and water. Never use harsh chemicals or abrasive cleaners. Rinse thoroughly with clean water
and then dry surfaces.
Childproof
safety
lock
Dispensing Hot Water
This water dispenser has a power saving Insta-HOT Feature button which activates the water heater
only when pressed, so you get hot water on demand without the cost of constantly heating water!
To dispense hot water, first press the Insta-HOT Feature activation button. The
red indicator light will begin flashing to indicate that the water heater is on and
active. In approximately 3 minutes the set temperature point will be reached
and the red light will stop flashing and remain on. The water is now ready to
be dispensed; squeeze the red handle and press downward. If water is not
immediately dispensed, the water will begin to cool and the red light will shut
off, requiring you to initiate another cycle.
grill
drip tray