Greenway Home Products VWD8000W-F Water Dispenser User Manual


 
4
When the system is first connected with power, the display window will show “8000” for a period of
5 seconds, following which the hot and cold water temperature will be displayed in °F and the hot and
cold water temperature display icons will illuminate.
1. Temperature Display Button
Press to convert the temperature from °F to °C. Temperature can be altered between Celcius
and Farenheit at any point during unit operation.
2. Hot Water Temperature Indicator
When the hot water switch (at rear of the dispenser) is turned to the “ON” position, the system
activation indicator will blink showing the water temperature gradually going up, and indicating that
the heating of the water is taking place.
3. Heating System Activation Indicator
Indicator will flash during the heating cycle providing a positive indicator of system operation.
4. Cold Water Temperature Indicator
When the cold water temperature switch (at the rear of the dispenser) is switched to the “ON”
position, the activation indicator will flash showing the water temperature gradually going down,
and indicating that the cooling of the water is taking place.
5. Cooling System Activation Indicator
Indicator will flash during the cooling cycle providing a positive indicator of system operation.
6. Cold Water Temperature Adjustment Buttons
Press and hold the button for 3 seconds. The cold water temperature display will blink.
Press the button to increase the temperature.
Press the button to decrease the temperature.
Press the button once to hold temperature.
Note: default system temperature is 5°C.
7a. Filter Replacement Indicator
The filter replacement indicator shows the remaining filter life based on a maximum volume of 900
Litres (approx. 240 gallons). Each of the six bars in the indicator is indicative of 150 L / 40
gallons. When the system flow meter reaches 900 L / 240 gallons, the icon will read as
and the text “Replace Filter” will flash. To reset the system the user must replace the filter, and
press + + .
Note: The filter replacement indicator will function regardless of whether a filtration system is installed.
If no filtration system is installed, the system must be reset based on volume, and/or time at a
minimum of twice a year (at approximately 6 month intervals).