Filter
Top Products
Page 2 Grindmaster Corporation 800 Series Coffee Grinders
Installation Instructions
1. Please read this manual before operating the grinder.
2. Carefully remove grinder from carton.
3. Place grinder in position on shelf, counter or other flat surface.
4. Plug grinder into standard electric outlet. Avoid using an extension cord.
5. Grind a small amount of whole bean coffee following operating instructions as described in this manual.
6. If there is any problem, consult the Troubleshooting Guide in this manual, (also on back of grinder.)
7. If you still cannot correct a problem, call Grindmaster’s Service Department for help, (800) 568-5715 M-F
8 AM - 6 PM EST
.
Operating Instructions
Your new coffee grinder is easy to operate and maintain. Before you place it in service, please have all personnel
familiarize themselves with these instructions; then see that this manual is kept in a convenient place where it will
always be available for ready reference.
How to Operate
1. Turn the selector knob to the desired grind setting.
2. Fill the hopper with the desired type and amount of whole bean coffee. Close the lid.
3. Place the bag underneath the spout.
4. Press the start button. *810 model - Press the grinder switch to the ON position.
5. The grinder will automatically stop when the bag is removed.**
* 810 model - Once coffee is ground, press the grinder switch to the OFF position or grinder will
continuously run.
** On models 835 and 875 the STOP button may be pressed after the grinder has completed grinding.
6. Remove bag from coffee spout once coffee is ground.
Grinds
Before shipment, your grinder is adjusted to accurately grind for each brewing method indicated. The Grinding
Burrs are made of an extremely hard and wear resistant alloy. From time to time grind adjustments (see Grind
Adjustment section in this manual) may be necessary as the burrs wear. If the grind runs coarser than expected
after normal adjustment and the grind time has increased , the burrs may have excess wear and should be
replaced. The burrs are warranted for (3) years or 30,000 pounds of coffee. Ask for a copy of our complete
Warranty for details. New burrs should always be installed as a pair, never one or the other, as they are accu-
rately ground and lapped in pairs.
Circuit Breaker
This grinder is equipped with a circuit breaker to protect the motor from overloading. When the circuit breaker
operates, the reset button will pop out approximately 1/4" which then cuts off power to the grinder. The reset
button is located on the front panel of the Model 810, 835 and 875. To reset the circuit breaker, push in the
reset button. You will hear a click as it resets. If the grinder does not operate after resetting the circuit breaker,
there may be an obstruction in the grinding mechanism that is stalling the motor. Turn the grind selector knob
all the way to the left. Try restarting the grinder. If the circuit breaker “trips” again, the obstruction was not able
to pass. In this case, the Grinder Head should be cleaned out as described in the Shear Disc Replacement sec-
tion of this manual.
Current
It is essential that full voltage and amperage always be available as it takes full power to grind coffee. NEVER
connect to an overloaded line or a two or three way plug, otherwise serious damage to the motor will occur. DO
NOT USE AN EXTENSION CORD.