Filter
Top Products
Shuttle Brewers & Airpot/Shuttle Brewers Page 11
Programming (cont.)
Settings Routine
Programming For Medium: Brew Time, Pulse Brewing & Bypass (refer to Table 2)
11. Press and hold both “up” and “down” arrows for 5 seconds.
12. All three brew lights will flash.
13. Press “Medium Brew” button.
Only “Medium” ready light illuminates during remaining steps.
14. Display will read “Br” (Brew Time).
15. Press “Medium Brew” button to go to next setting.
16. Display will read set brew time in minutes and seconds (0.01-6.00). Default is “2.40”.
17. Press “up” or “down” arrow to change value. (1 second increments)
18. Press “Medium Brew” button to accept and go to next setting.
19. Display will read “P-b” (Pulse Brewing).
10. Press “Medium Brew” button to accept and go to next setting.
11. Display will read “Off” or “1” – “6” (number of pulses). Default is 2.
12. Press “up” or “down” arrow to change value (1 second increments). (Approximately 0.8 oz./second.)
13. Press “Medium Brew” button to accept and go to next setting.
Note: If “Off” is selected, skip pulse timing steps.
14. Display will read “0.05” – “0.60” (pulse ON time for each pulse). Default is “0.30”.
15. Press “up” or “down” arrow to change value. (increments of 1 second)
16. Press “Medium Brew” button to accept and go to next setting.
17. Display will read “0.05” – “0.60” (pulse OFF time for each pulse). Default is “0.30”.
18. Press “up” or “down” arrow to change value. (increments of 1 second)
19. Press “Medium Brew” button to accept and go to next setting.
20. Display will read “b-P” (percent of brew volume to be bypassed).
21. Press “Medium Brew” button to go to next setting.
22. Display will read “Off” or “1” – “33” (bypass %). Default is “OFF”.
23. Press “up” or “down” arrow to change value. (increments of 1 percent)
24. Press “Medium Brew” button to accept and clear display.
Table 2
(OFF, 1 - 6)
TO
BYPASS
ADVANCE
PULSE BREW
ADJUST
BREW TIME
READING
# OF PULSES
BYPASS % (OFF, 1-33)
DISPLAY
(MAX MAY CHANGE DEPENDING ON RATIO)
1. PRESS-AND-HOLD UP & DOWN ARROWS FOR 5 SECONDS.
2. READY LIGHTS WILL FLASH.
3. PRESS BREW BUTTON FOR MEDIUM "M".
4. MEDIUM READY LIGHT FLASHES THROUGHOUT ROUTINE.
5. DISPLAY WILL READ AS FOLLOWS:
BREW TIME (0:01-6:00)
2 minutes, 40 seconds shown
PULSE OFF TIME (0:05-0:60)
# of seconds shown
PULSE ON TIME (0:05-0:60)
# of seconds shown