Grizzly G0484 Mixer User Manual


  Open as PDF
of 48
 


To mill a workpiece:
1 Page
16Figure 16
2 
      

Note: For special milling operations, loosen
the headstock tilt lock nuts and rotate the
headstock to the needed angle (Figure 17).
Note:If you are only milling in one direction,
lock the unused table slide in place.
3   Choosing Spindle RPM  Page
19        


4 Figure 18
       

Note: For maximum spindle rigidity while
milling, keep the spindle retracted into the
headstock as far as possible with the quill
headstock lock levers locked and the fine
feed lock knob tightened.

       





5 
6 FR


7 
        
      

Milling /Drilling
Figure 18.
Figure 17.
Figure 16.




Failure to follow RPM and Feed Rate
Guidelines may threaten operator safety
from ejected parts or broken tools.
 previous next