Filter
Top Products
15 ENGLISH
OPERATION ________________________________
Preparation
1 Remove all packaging and sticker materials and
dispose of them according to the applicable
legal regulation.
2 Before using of the appliance for the first time,
clean all parts which come into contact with
water carefully. (See the “Cleaning and care”
section).
3 Completely roll out the power cord from the
bottom of the base
E
.
4 Rinse the water tank
C
with water. This will
remove any remaining manufacturing residues
from the inside of the water tank .
5 Set the water tank
C
on its base
E
. Make sure
that the kettle is sitting in an upright position and
that it is sitting on the base correctly and in a
stable position.
6 Clean kettle well before initial use and discard
water of first two boiling cycles.
Operation
1 Push the lid release button
G
on the kettle to
open the lid
F
.
– The lid
F
opens automatically.
2 Fill the water tank
C
with water.
Notes
57
Do not place the water tank
C
on the base
E
while filling it with water.
57
Never fill the water tank
C
above the maxi-
mum level indicator or below the minimum
level indicator.
3 Close the lid
F
until it clicks into place.
4 Place the water tank
C
on the base
E
. Make
sure that it is sitting in an upright and stable
position.
5 Insert the plug into the wall socket.
6 Press down On/Off switch
I
to >> I<< position.
– On/Off switch
I
illuminates and heating
process begins.
Note
57
Lid
F
should always be closed during the
heating process; otherwise the kettle will not
switch off automatically.
7 After a few minutes, the water will start to boil.
The kettle switches off automatically.
– On/Off switch
I
switches off and the
illumination disappears.
Note
57
If you want to stop the heating, press the On/
Off switch
I
up to >>0<< position.
8 Disconnect the plug from the wall socket.
9 Take the water tank
C
from the base
E
. Only
hold it by the handle
H
.
Caution
57
Do not open the lid
F
as hot water could
splash out. Make sure that no water splashes
onto the base
E
.
10 Pour the water from the spout
A
to the cup or
glass you want to use.
Notes
57
If you want to continue the heating process,
repeat the procedure from 1 to 10.
57
Let the kettle cool down between each heat-
ing process.
Hints and Tips
57
The kettle is equipped with a filter
B
which
filters out limestone and other residues when
the water is being poured out.
57
Use softened or filtered water to prevent lime
build-up.